Jump to content

英文维基 | 中文维基 | 日文维基 | 草榴社区

Diindenoperylene

From Wikipedia, the free encyclopedia
Diindenoperylene
Skeletal formula
Ball-and-stick model
Names
Preferred IUPAC name
Diindeno[1,2,3-cd:1′,2′,3′-lm]perylene
Other names
Periflanthen; Periflanthene
Identifiers
3D model (JSmol)
Abbreviations DIP
ChemSpider
ECHA InfoCard 100.005.343 Edit this at Wikidata
UNII
  • InChI=1S/C32H16/c1-2-6-18-17(5-1)21-9-13-25-27-15-11-23-19-7-3-4-8-20(19)24-12-16-28(32(27)30(23)24)26-14-10-22(18)29(21)31(25)26/h1-16H ☒N
    Key: BKMIWBZIQAAZBD-UHFFFAOYSA-N ☒N
  • InChI=1/C32H16/c1-2-6-18-17(5-1)21-9-13-25-27-15-11-23-19-7-3-4-8-20(19)24-12-16-28(32(27)30(23)24)26-14-10-22(18)29(21)31(25)26/h1-16H
    Key: BKMIWBZIQAAZBD-UHFFFAOYAB
  • C1=CC2=C3C=CC4=C5C=CC6=C7C=CC=CC7=C8C6=C5C(=C9C4=C3C(=C2C=C1)C=C9)C=C8
Properties
C32H16
Molar mass 400.480 g·mol−1
Appearance Orange solid
Boiling point >330 °C (sublimation)
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☒N verify (what is checkY☒N ?)

Diindenoperylene (DIP) is an organic semiconductor which receives attention because of its potential application in optoelectronics (solar cells, OLEDs) and electronics (RFID tags). DIP is a planar perylene derivative with two indeno-groups attached to opposite sides of the perylene core. Its chemical formula is C32H16, the full chemical name is diindeno[1,2,3-cd:1',2',3'-lm]perylene. Its chemical synthesis has been described.[1][2]

Properties and uses

[edit]

The molecular weight is 400.48 g/mol, the dimensions of the molecule in its plane are ~18.4×7 Å.[3] and its sublimation temperature is above 330 °C.[4] It is non-polar and therefore only slightly soluble, for example in acetone.

DIP is a red dye[5] and has been used as active material for optical recording.[6] Because of its ‘perylene-type’ optical emission in the visible spectrum, it has also been used in organic light emitting diodes.[7] Organic field effect transistors of DIP have been studied.[8] The charge carrier mobility achieved was up to 0.1 cm2/(V·s) for thin film transistors with silicon dioxide as gate dielectric, making DIP a good candidate for further optimisation.[9]

The structure of bulk DIP crystals has recently been studied by Pflaum et al., who found two distinct phases at room temperature and at temperatures above 160 °C. In thin films for growth ‘near equilibrium’ (at substrate temperature of about 130 °C) by organic molecular beam deposition (OMBD), DIP has been shown to order very well.[2][10] The structure of thin DIP films has been characterized ‘post-growth’,[2][11][12][13] with structures differing from the room-temperature bulk structure. These thin-film structures depend on the substrate used, and also on the substrate temperature during growth.[10]

References

[edit]
  1. ^ J. von Braun, G. Manz, in Deutsches Reichspatentamt, Berlin. (Germany, 1934).
  2. ^ a b c E. Clar, Polycyclic hydrocarbons (Academic Press, London, New York, 1964), p. 2
  3. ^ Dürr, A. C.; Schreiber, F.; Münch, M.; Karl, N.; Krause, B.; Kruppa, V.; Dosch, H. (2002). "High structural order in thin films of the organic semiconductor diindenoperylene". Applied Physics Letters. 81 (12): 2276. Bibcode:2002ApPhL..81.2276D. doi:10.1063/1.1508436.
  4. ^ A. C. Dürr, Ph.D. thesis, Universität Stuttgart (2002)
  5. ^ Heilig, M; Domhan, M; Port, H (2004). "Optical properties and morphology of thin diindenoperylene films". Journal of Luminescence. 110 (4): 290. Bibcode:2004JLum..110..290H. doi:10.1016/j.jlumin.2004.08.023.
  6. ^ H. E. Simmons. (1987)
  7. ^ H. Antoniadis, A. J. Bard. (Hewlett-Packard Company & The Board of Regents of The University of Palo Alto, CA, 1997)
  8. ^ M. Münch, Ph.D. thesis, Universität Stuttgart (2001)
  9. ^ N. Karl, in Organic Electronic Materials R. Farchioni, G. Grosso, Eds. (Springer, Berlin, 2001), vol. II, ISBN 3-540-66721-0 pp. 283 ff.
  10. ^ a b Kowarik, S.; Gerlach, A.; Sellner, S.; Schreiber, F.; Cavalcanti, L.; Konovalov, O. (2006). "Real-Time Observation of Structural and Orientational Transitions during Growth of Organic Thin Films". Physical Review Letters. 96 (12): 125504. Bibcode:2006PhRvL..96l5504K. doi:10.1103/PhysRevLett.96.125504. PMID 16605925. S2CID 1223144.
  11. ^ Dürr, A.; Schreiber, F.; Ritley, K.; Kruppa, V.; Krug, J.; Dosch, H.; Struth, B. (2003). "Rapid Roughening in Thin Film Growth of an Organic Semiconductor (Diindenoperylene)". Physical Review Letters. 90 (1): 016104. Bibcode:2003PhRvL..90a6104D. doi:10.1103/PhysRevLett.90.016104. PMID 12570630.
  12. ^ Dürr, A.; Koch, N.; Kelsch, M.; Rühm, A.; Ghijsen, J.; Johnson, R.; Pireaux, J.-J.; Schwartz, J.; Schreiber, F.; et al. (2003). "Interplay between morphology, structure, and electronic properties at diindenoperylene-gold interfaces". Physical Review B. 68 (11): 115428. Bibcode:2003PhRvB..68k5428D. doi:10.1103/PhysRevB.68.115428.
  13. ^ Hoshino, A; Isoda, Seiji; Kobayashi, Takashi (1991). "Epitaxial growth of organic crystals on organic substrates — polynuclear aromatic hydrocarbons". Journal of Crystal Growth. 115 (1–4): 826–830. Bibcode:1991JCrGr.115..826H. doi:10.1016/0022-0248(91)90854-X.